![]() ![]() Install the software, select the appropriate parallel port, the interface type and the correct chip version (don't use “AVR Auto”, the current software version doesn't work correctly with the Tiny2313). STEP 6: Do “Setup -> Calibration” PonyProg is a great software for flash memory programming. Look at the following diagram, Fig: The AVR connections. ![]() In the next step select "AVR micro" and your microcontroller To answer another question I had earlier, the PonyProg progress bar dialog has an "Abort" button on it which can be used during either programming or verifying. 1 2 13 14 SER/ISP JMP S C K 1 3 64-pin AVR processors (incl. ![]() It supports only serial and parallel connections to PC. If it has been used before, it may be configured for an external clock mode, which requires that you supply a clock signal. PonyProg is used for installation, after connecting the circuit, go to Setup / Interface setup in the upper menu and mark I / O settings as programmer Serial, SI Prog API, COM1 Ponyprog enables the user to write, verify and erase data on the microchip. To do this go to "Setup" menu and select "Interface Setup". Before you can use the USB AVR ATmega8 microcontroller programmer circuit “ is usb_programmer_av-910. COMPILE PONYPROG ON UBUNTU PonyProg is device programming software for the SI Prog serial interface programmer designed by Claudio Lanconelli. In the circuit diagram I have already shown the pin out of the BC 547 ic. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |